RVNI Front Headlights for 08-10 Ford F-250 F-350 F-450 Super Duty Black Amber Corner

<p><b>Description:</b> <br>A new pair of headlights from ours allow you to see the road in front of you clearly during the night and in any bad weather that may arise.<br><br>Gives you and your family safer nighttime driving.<br><br>Makes your car looks newer.<br><br>See road markings and traffic sighs better.<br><br>Driving at night can be a scary proposition - and it's even scarier if you can't see the road well.<br><br>A dim, cloudy, yellowed, or otherwise damaged or non-functioning headlight makes driving dangerous,not only is your own safety at risk, but the safety of others is as well.<br><br></p><p><b>SPECIFICATION:</b></p>High Beam: H13(Not included)<br>Low Beam: H13(Not included)<br>Turn Signal Light: 3157(Not included)<br>Replace Parts Number:7C3Z-13008BA,7C3Z-13008AA<br>Dimensions:29.92*19.29*9.06 inch<br>Weight:17.59 lb<br><p><b>FITMENT:</b></p>2008 2009 2010 Ford F-250/ F-350/ F-450 Super Duty models only<br>Does not fit models with sealed beam headlights<br><p><b>Package includes:</b></p>2 x Headlights(1x Driver's side &amp; 1x passenger's sides),bulbs are Not included<br><p><b>Note:</b></p>Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The center lines of the headlights should not be any higher than 3.5 feet above the ground.<br><br><p><b>1. Find the adjustment screws. </b></p>Firstly, locate the adjustment screws on your vehicle.<br><br><p><b>2. Adjust the headlights individually. </b></p>The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.<br><br><p><b>3. Adjust the vertical field.</b></p> The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.<br><br><p><b>4. Adjust the horizontal field.</b></p> The screw on the side of the light housing should be turned to get the right/left adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.<br><br><p><b>5. Test your results.</b></p>

• Completely sealed: Prevents moisture from being trapped inside the housing
• One-way vent: Drives out moisture and avoids lens misting
• Brighter & safer：Makes your vehicle more visible to other road users to increase your driving safety
• PC lens: Impact resistance for an enhanced driving experience in any environment